Sun Visor Warning Label Blackouts : Chevrolet Silverado ZR2/RST/Z71/High Country/TrailBoss/LT

Hate those lame warning stickers on your sunvisor?! Who doesn’t?! Those ugly yellow & white warning labels would look A LOT better if they weren't on your visors..but unfortunately, they are…and they’re pretty much permanent...UNTIL NOW!! With these easy to apply "peel & stick" decals from Khaoticreations, you can give your interior that nice clean appearance you really want by covering those unsightly warning labels PERMANENTLY!! Sold as a set of 2. Khaoticreations IS NOT RESPONSIBLE for you receiving incorrect blackout dimensions. Please specify if you need dimensions differently than above specified size (5.5” x 3.5”). Each label measures 5.5” x 3.5” - if you’re looking for a different size, please leave the requested measurements in the personalization section. These covers come with your choice of any logos listed above (as well as not listed - just leave your requested choice in the personalization section). * * For a completely “clean” & blended look, opt for a plain blackout. * * > > Blackouts are available in any color, pattern, or vinyl of your choice! ..just simply request if your choice isn’t available - Custom made-to-order! < < - Made to the highest quality standards with superior & top-rated vinyl, such as Oracal651. - rated 7+ years!! - Made with Premium Self-Adhesive vinyl. (Vinyl is removable but not reusable.) - Easy to Apply / just peel & stick to any hard/smooth surface. - Suitable for both indoor applications (7 yrs.) and/or outdoor (5 yrs.) - Resistant to fading, weatherproof/waterproof material. What makes up a Vinyl Decal/Sticker: *Top Layer: Pre-Mask/Application Tape. Used to hold the separate pieces of vinyl that make up the decal together until after installation *Middle Layer: The pieces of vinyl that make up the actual decal. *Bottom Layer: Release Liner/Backer Paper. The first layer that will be removed during installation * Your Decal Application Instructions & Care Guide * 1. Clean application surface and allow too fully dry (use isopropyl alcohol for best results). 2. Allow your surface to fully dry & use squeegee or credit card to smooth out the vinyl and backing paper before applying to desired area. 3. Carefully remove the paper backing from your decal leaving only the decal & top transfer sheet (if transfer tape is needed to transfer vinyl successfully. 4. Align the decal in desired spot & press onto surface (press from the middle outwards for best results). The vinyl is “pressure activated” and requires strong pressure for best adherance. 5. Now use your squeegee (or credit card) once more for optimal results & to achieve the best adherance. “Smooth” decal/sticker surface & eliminate any bubbles (if present) starting from the top down. 6. Once your decal is fully adhered, SLOWLY peel away transfer tape (if required for decal) starting from the corners (BE PATIENT & gentle while removing transfer tape or you may risk ripping/pulling layer(s) with the top transfer sheet removal. 7.THAT’S IT - you did it!! …Doesn’t your vehicle look sooo much cleaner now?!